Unfortunately we do not accept new members for free, Now Registration cost 30€, if you are interesting Send Email to [email protected]
P1610&P0602
20-04-2016, 13:46 PM,
Post: #1
|
|||
|
|||
P1610&P0602
Hello,
Owner of the car had problems with it, and decided to try a different ECU. He swapped the old one, put in a different, of course it would not run, and put the old one back. Now he has the following fault codes as active, P1610 - Immobilizer function not programmed P0602 - Control module programming error He had some guy try it with opcom 08/2010 chinaclone, and said that programming the unit is not possible with that hardware. Is rectifying the problem a job for a tech2 or just a better opcom? Or is it even possible to program these out, given if there is not anything wrong with the car itself? I know the owner, and i believe him that these were not present before. Car is -99 Astra F, with 1.6L X16XEL engine. |
|||
21-04-2016, 08:08 AM,
Post: #2
|
|||
|
|||
RE: P1610&P0602
You could try to reset the ECU and Immo and try to reprogram the ECU.
|
|||
21-04-2016, 16:23 PM,
Post: #3
|
|||
|
|||
RE: P1610&P0602
This issue is a bit hard for me, as my friend who's having these problems lives 300 miles from me, and I tried to fix it with his friends op-com with teamviewer and phone.
Under ECU, the programming tab is greyed out, i havent used this op-com, but i would think the reset should be under there. Has anyone tried to do this to the car in question with op-com, so i would know is the clone's software able to do this? |
|||
06-06-2016, 09:20 AM,
Post: #4
|
|||
|
|||
RE: P1610&P0602
You must resynchronize Immo and ECU. You must to know a pin prior to do something. You can get the pin from Opel dealer, or to read it from Immo by directly connecting to its MCU
|
|||
« Next Oldest | Next Newest »
|
Users browsing this thread:
1 Guest(s)
1 Guest(s)
Return to TopReturn to Content