[Ryu357]

Hi all I bought a 2008 Peugeot Partner van which only had a transponder key with it. When I tried to program a new remote key into it the complete system shut down bi have no electrics at all when I turn the key. I have tried to reboot the bsi by usual bonnet up battery off and have also tried battery terminals together but nothing. Anybody any ideas or is it going to be a complete new bsi kit? Thanks

[superpjok]

Hi!
Stolen from
www petercoopercarrepairs co uk

Peugeot BSi reboot procedure

Some of you will have already come across a strange problem when programming
keys on 2002 onwards Bsi equipped Peugeot. This usually presents
itself as a complete instrument cluster failure after the keys have
been programmed when the customer comes to collect the car.
BSI Unit
The BSI unit is basically a computer which
handles a multitude of functions such as
odometer value, central locking, lights and
immobiliser. Some later Bsi units are liable
to corrupt their own software program if
not “woken up” in a specific way after
programming keys or battery disconnection.
The details of this are explored
thoroughly in a Peugeot TSB but I will
summarise for you briefly.
Procedure for Initialising the BSI after key learning
1. Disconnect the diagnostic tool.
2. Put the driver’s window down, lift the bonnet and ensure all
equipment is switched off.
3. Ensure all doors are closed and remove key from the
ignition.
4. Wait for 3 minutes, disconnect the vehicle battery and wait
15 seconds.
5. Reconnect the vehicle battery, wait a further 10 seconds (do
not open doors.)
6. Switch on the side lights through the driver's window.
7. Switch on the ignition and check system’s functionality.
8. Hold lock button on key down for 10 seconds.
9.remove key open & close door test central locking system
10. Start the engine and complete the system’s check.
Failure to follow this procedure could result in incorrect operation of many
BSI related items.
It did take three attempts following this procedure before it worked.

regs

[matty879]

Hi all I bought a 2008 Peugeot Partner van which only had a transponder key with it. When I tried to program a new remote key into it the complete system shut down bi have no electrics at all when I turn the key. I have tried to reboot the bsi by usual bonnet up battery off and have also tried battery terminals together but nothing. Anybody any ideas or is it going to be a complete new bsi kit? Thanks

what did you try to programme the new key with?
i have a similair prob with a 207 1.4 hdi.if you find a solution do share

[Ryu357]

Hi all I bought a 2008 Peugeot Partner van which only had a transponder key with it. When I tried to program a new remote key into it the complete system shut down bi have no electrics at all when I turn the key. I have tried to reboot the bsi by usual bonnet up battery off and have also tried battery terminals together but nothing. Anybody any ideas or is it going to be a complete new bsi kit? Thanks

what did you try to programme the new key with?
i have a similair prob with a 207 1.4 hdi.if you find a solution do share

I was using FVDI to programme the the key and had to replace the ecu and bsi boards which I got off eBay. I swapped the chip from the new key into the existing one so I didn't have to change the ignition barrel over. Worked 100%. Hope this helps.