[andyhud]

Hi Guys

Swapped out the door controllers on a Q7 E-Tron for Highline version (792/793 and 795's in the rear doors) but the window up/down is the wrong way round so if you push down the window goes up and up the window goes down.

Coding has been carried over and software version seems right, but I read on another forum that:

"I read somewhere that to change window motor direction you need to read the eeprom and tick bit 5 (reversal of power window motor) for address BD,CE and DF'"


or perhaps a new dataset? 

The door controllers although the part numbers are the same came from an A4 and A5.

Thanks!

Andy


Address BB: Door Rear Drv (J388)       Labels:* None

   Part No SW: 4M0 959 795 E    HW: 4M0 959 795 C

   Component: TSG HFS       009 0057  

   Serial number: 0000190632578 

   Coding: 004D98000001008000003080

   Shop #: WSC 06758 128 28888

   ASAM Dataset: EV_DCU2RearDriveMAXHCONT 001005

   ROD: EV_DCU2RearDriveMAXHCONT.rod

   VCID: 42DD49BFC40BC657C81-8016



1 Fault Found:

196660 - Motor for Window Regulator 

          B1487 54 [009] - Missing Calibration / Basic Setting

          Confirmed - Tested Since Memory Clear

             Freeze Frame:

                    Fault Status: 00000001

                    Fault Priority: 5

                    Fault Frequency: 1

                    Reset counter: 50

                    Mileage: 30746 km

                    Date: 2018.10.22

                    Time: 11:13:43





-------------------------------------------------------------------------------

Address BC: Door Rear Pass (J389)       Labels:* None

   Part No SW: 4M0 959 795 E    HW: 4M0 959 795 C

   Component: TSG HBFS      009 0057  

   Serial number: 0000205186244 

   Coding: 004D98000001008000003080

   Shop #: WSC 06758 128 28888

   ASAM Dataset: EV_DCU2RearPasseMAXHCONT 001005

   ROD: EV_DCU2RearPasseMAXHCONT.rod

   VCID: 42DD49BFC40BC657C81-8016



1 Fault Found:

196660 - Motor for Window Regulator 

          B1487 54 [009] - Missing Calibration / Basic Setting

          Confirmed - Tested Since Memory Clear

             Freeze Frame:

                    Fault Status: 00000001

                    Fault Priority: 5

                    Fault Frequency: 1

                    Reset counter: 50

                    Mileage: 30746 km
                    Date: 2018.10.22

[mrbla]

1st software version 60 is newest.

2nd if you got them from Q7 and installed them into A4/A5 a new dataset might be necessary.

But did you do a calibration/basic setting of the window?
Also the coding looks wrong.

Can you post your model and config of the door?