[mreza73]

Hi again
i need calibration codes for ford focus
VIN: WF0FD95L0ALK19141

i also need repair manual and wiring for this car because it's german ford (MFG by ford werke gmbh) it's different with USA focus work shop

[mreza73]

If someone sends me just calibration it will be very good
tnx

[sev611]

I think you should give the gem module closer look because the only module ids is seeing is the ipc al module is connected by the gem indeed see the connetors on the uppef levt side of gem and on the down side the 2connectors get loose and then there are no comunication to the othef module check dlc 3-11 and 6-14 there should be 60ohm +- 2 ohm

[mreza73]

I think you should give the gem module closer look because the only module ids is seeing is the ipc al module is connected by the gem indeed see the connetors on the uppef levt side of gem and on the down side the 2connectors get loose and then there are no comunication to the othef module check dlc 3-11 and 6-14 there should be 60ohm +- 2 ohm

thanks i will check can network ohms but when i was connect MS can from radio to GEM module (direct) it's passed the network test but not any other modules pass the test
and i need wiring diagram for testing can on PCM socket side
my main problem is finding CAN wires on pcm

this is my GEM module and all ceonnector are connected and seems to be ok
(two sockets is on back side)

[sev611]

I have tried to print some wireing diagrams as pdf but dont know how to attach them to this post
ps i think i found out
rgds sev

etis.dealerconnection.com_wiring_prepareEmbeddedSVG.pdfpats.pdf
File Type:
Downloaded:	37 times
Size:	136.44 KB