Unfortunately we do not accept new members for free, Now Registration cost 30€, if you are interesting Send Email to [email protected]
Solved ✔ Opcom SWCAN doesn't work
31-07-2016, 18:33 PM,
Post: #1
|
|||
|
|||
Opcom SWCAN doesn't work
It was fw v1.39 and older sw 2010, and opel corsaD 2007y...I need to go inside IPC and SDM on SWCAN 33kbps but not possible...other protocols work fine, K line, CAN MSCAN, HSCAN,..
than I have upgraded form v1.39 ti v1.59 and use VAUXCOM....same thing...so, I have concluded it is about interface problem. Did somebody has same problem...how can I solve this? Till this moment I have tried to change place of all relays, replace position of U5, U6 (MCP2551I), ...unfortunately w/o success. which one pin or relay is SWCAN? regards, cuby |
|||
31-07-2016, 19:53 PM,
Post: #2
|
|||
|
|||
RE: Opcom SWCAN doesn't work (SOLVED)
(31-07-2016, 18:33 PM)cubica Wrote: It was fw v1.39 and older sw 2010, and opel corsaD 2007y...I need to go inside IPC and SDM on SWCAN 33kbps but not possible...other protocols work fine, K line, CAN MSCAN, HSCAN,.. solved..one of marked relays...i will tell u which one later...I have changed position of them..now SWCAN works but can not see EHU... The car is started, all components ECM-BCM-immo-SDM-IPC are programmed successfully !! regards, cuby |
|||
08-08-2016, 14:25 PM,
Post: #3
|
|||
|
|||
RE: Opcom SWCAN doesn't work
Relay for SWCAN is nearest behind of LM317T (back metal side LM 317T)
Quality tool as the beautiful woman...
|
|||
« Next Oldest | Next Newest »
|
Users browsing this thread:
2 Guest(s)
2 Guest(s)
Return to TopReturn to Content