[HERVE06300]

HELLO
Windows 10 native intaled 3 days ago
I have VAS 5054A with serial #083600808
When I try to install drivers windows says "not found drivers"
any idea/solution ?

here pics of my vas5054a PCB





the good think is that you don't need to unsoldering ram memories

[Enabled]

1. That is by far the worst VAS5054a clone I have seen.

2. You need to be on Win 7-10 32-bit and install the drivers correctly. See the instructions, they were very well written.

[HERVE06300]

1. That is by far the worst VAS5054a clone I have seen.

That's I supposed

2. You need to be on Win 7-10 32-bit and install the drivers correctly. See the instructions, they were very well written.


I do all but I plug vas5054a (I block W10 to install automatically drivers) I see Vas5054 i make "driver update" and i chose good place But I Have "no driver found"

I suppose my vas5054 is very bad
But work to read audi s4 b8 (usb mode only)

[HERVE06300]

Another question

Tomorrow I can use original KTS of a friend

How I can change vas5054a passthru to kts pasthru in xentry ?

[HERVE06300]

With a new vas5054a vci works fine with

smart 450 (kiss point of clutch)
smart 451 (kiss point of clutch)

The only think is when ignition on/off :

FIRST TIME USE THE KEY after change the file

But don't work with w208.444 2002 normal or not ?

[konstantin82]

No pass in DAS special function. Copy that file in folder where DAS instaled.
I recomend not fully replace the old one. Just rename it. Then paste that file.

[konstantin82]

With a new vas5054a vci works fine with

smart 450 (kiss point of clutch)
smart 451 (kiss point of clutch)

The only think is when ignition on/off :

FIRST TIME USE THE KEY after change the file

But don't work with w208.444 2002 normal or not ?

I just create a 2 .bat files which replace the global.sim in DAS folder. And create shortcuts for them on a tasck panel.

[HERVE06300]

I try to change the file but not work

When I start short test I have this :



Ans when I try to open calculator I have :



Start multiplexer fail
Possible cause : the diagnostic system data sectors are not complete or defective
contact help line

[konstantin82]

I try to change the file but not work

When I start short test I have this :



Ans when I try to open calculator I have :



Start multiplexer fail
Possible cause : the diagnostic system data sectors are not complete or defective
contact help line

It's happens when you try to diagnose non CAN system. And system on K-Line which using not 7pin of obd2.
In cars from 2005 Xentry Passthru, almost, works fine, except X463 (for mine expirience). On older cars different ecus using different pins in obd plug. To diagnose them you need a multiplexer.

[HERVE06300]

Ok thanks a lot

I will try to find multiplexer