[Johnner]

@ MinhCao, that will not count properly.

@ liangyupei, here is your file, 60,000 exactly.

@ clusters yes !You are right.I've write the bin and it show 60000km!THX!

---

Always provide ur orginal km when u post the dump ur orginal is 135346, and cluster change the dump exatly 60000 perfect. MinhCao posted dump will freez the km will not count

@zckariya70 Yes you are right!The dump of MinhCao freez the km will not count,and I write the dump of clusters and it shows 60000KM!THX!!

Dear all,
I very surprise that my file is not count.
Your car have 93c86 eepromt but the algo is the same LandCruiser 93c66 I've done
I always do the procedure :
Disconnect the battery - remove the dashboard - desolder the chip eepromt - read/write the bin file to the chip - solder back the chip eepromt - install the dashboard - reconnect the battery - drive test - done.
one year ago, sometime I didn't disconnect the battery, and I have the problems that some dash was not count. So I always disconnect the battery before remove the dash and only reconnect the battery after install completely the dash, that problem gone.
Best regard.

As i understand you use the Tachosoft to change the dump that i not work becuase you are using 93C66 analog, i am just new as you are just waiting guidance from expert decode dump without software.
Please help us

First thing you do mate....bin that crap called Tachos*it....learn to do the maths yourself...if you run into serious encryption like,for example, Vag..then use trusted tools...

[fiazhnd]

@ MinhCao, that will not count properly.

@ liangyupei, here is your file, 60,000 exactly.

@ clusters yes !You are right.I've write the bin and it show 60000km!THX!

---

Always provide ur orginal km when u post the dump ur orginal is 135346, and cluster change the dump exatly 60000 perfect. MinhCao posted dump will freez the km will not count

@zckariya70 Yes you are right!The dump of MinhCao freez the km will not count,and I write the dump of clusters and it shows 60000KM!THX!!

Dear all,
I very surprise that my file is not count.
Your car have 93c86 eepromt but the algo is the same LandCruiser 93c66 I've done
I always do the procedure :
Disconnect the battery - remove the dashboard - desolder the chip eepromt - read/write the bin file to the chip - solder back the chip eepromt - install the dashboard - reconnect the battery - drive test - done.
one year ago, sometime I didn't disconnect the battery, and I have the problems that some dash was not count. So I always disconnect the battery before remove the dash and only reconnect the battery after install completely the dash, that problem gone.
Best regard.

As i understand you use the Tachosoft to change the dump that i not work becuase you are using 93C66 analog, i am just new as you are just waiting guidance from expert decode dump without software.
Please help us

First thing you do mate....bin that crap called Tachos*it....learn to do the maths yourself...if you run into serious encryption like,for example, Vag..then use trusted tools...

That what i was trying to tell you i am following Sir Cluster and learning many things from him, the algorithm have two part first 17 byte and next 17 byte consit of 00 and ff if you want to use your Hex value as C9 0D than make next 17 byte as FF only no 00.

@ clusters
Sir i cant able to figure it out wh/how we need to split our code into two part (i.e. CA 0D = 7 byte C9 0D = 10 Byte) when original dump was 1A1F = 9 and 191F = 8.