Unfortunately we do not accept new members for free, Now Registration cost 30€, if you are interesting Send Email to [email protected]

Solved ✔ Corsa c dash and bcm issues
02-12-2016, 14:25 PM,
Post: #11
RE: Corsa c dash and bcm issues
Don't forget to get some pictures if you find the problem............wink2

If My Post Was Helpful
Than Please Click On Thanks & Rep..under
Reputation: +1 - dil6222 [+1]
02-12-2016, 16:41 PM,
Post: #12
RE: Corsa c dash and bcm issues
ECU to BCM loom twisted pair


Attached Files Thumbnail(s)
   
[+] 6 users say Thank You to racin-snake for this post
03-12-2016, 16:33 PM,
Post: #13
RE: Corsa c dash and bcm issues
Hello aIl ive checked the can wires and cant find the
Issue I even went as far as taking complete dash out to get to complete loom that
runs along bulkhead behind dash
I ran test light between all sets of can plugs and visually checked all seem fine
I even checked for breaks between immo ring and IPC/clocks.

the only thing that I noted was abs light is on dash also I checked plug on abs controller where can wires route through to get to ecu the plug had water in bottom near blue gel I dryed it but didn't make a difference i also tried bridging can wires on abs controller plug but again no difference. As I said abs light is on but its not storing any fault codes which is strange. light but no codes ??
service light remains non appearing and Insp still shows 0 and won't reset. Need a bcm and ICP dump if anyone has 1 smile
Would a dead Kline wire cause same issue?

under If mine or others posts and info are helpful please give thanks/rep smile yes
05-12-2016, 20:05 PM,
Post: #14
RE: Corsa c dash and bcm issues
(03-12-2016, 16:33 PM)dil6222 Wrote:  Would a dead Kline wire cause same issue?

If k line was dead you wouldn't have comms with engine ecu try unplugging immobiliser module the US type ones go down cause non start faults also no comms
Reputation: +1 - dil6222 [+1]
[+] 4 users say Thank You to racin-snake for this post
06-12-2016, 08:58 AM, (This post was last modified: 06-12-2016, 19:05 PM by dil6222.)
Post: #15
RE: Corsa c dash and bcm issues
Quote='racin-snake' pid='202293' dateline='14809683give8096832dil6222' pid='201715' dateline='1480782827']

Would a dead Kline wire cause same issue?

[/quote]

If k line was dead you wouldn't have comms with engine ecu try unplugging immobiliser module the US type ones go down cause non start faults also no comms
[/quote]
That's what I thought as I have Kline comms it can't be that.
Im thinking along the line of abs controller as it gives me negative answer to service error in opcom and the abs light is on constantly and as it's first in chain before bcm etc will check immo though racing snake cheers for extra info smile
I'll give in when im dead lol

PS what is the I'd I should be programming to bcm and Ipc as it only programs 8 digits is this correct as vin number is longer?

under If mine or others posts and info are helpful please give thanks/rep smile yes
08-12-2016, 10:12 AM, (This post was last modified: 08-12-2016, 10:26 AM by dil6222.)
Post: #16
RE: Corsa c dash and bcm issues
SOLVED

after trying countless solutions and checking abs ecu
and removing complete engine to instrument wiring loom and Can twisted pair half a dozen times
( pictures later ) I found the devil hiding away in a little green wire smile
about six inchs from the abs ecu plug wrapped inside the twist was a pin hole no or visible break whatsoever just a tiny hole probably 0.25mm.
I cut the piece out and rejoined all good now everything works

Conclusion smile

I nearly ruled out can wires as tested with test light but after checking all other possibilitys knew it had to be a break I had already checked them few times so as loom was out I checked again a inch a time under a bright lamp and found it fixed and coded complete system on my living room floor lol.

worth noting is that immo/service light will be completely gone non appearing for this fault , the light will come back when wires fixed and ipc may play up and not program till fixed also. smile

i will tape up can wires separate and then tape them into loom for added protection so it shouldnt ever happen again.

big thanks to racing snake and ashraf biggrin

under If mine or others posts and info are helpful please give thanks/rep smile yes
[+] 1 user says Thank You to dil6222 for this post


Possibly Related Threads…
Thread Author Replies Views Last Post
ZTAudi 8P0920932D Micronas Dash - no Adress 25 chrisi1909 2 54 24-03-2024, 10:07 AM
Last Post: chrisi1909
YTMercedes w204 mileage dash correction wosanyn31 1 72 21-03-2024, 20:06 PM
Last Post: nikolanik
  Solved ✔ Iveco 2015 mileage dash+bcm Lifestyle 1 81 21-03-2024, 15:14 PM
Last Post: Lifestyle
VToyota Toyota LC200 dash 93C86 miles to km help ttkkas01 1 49 20-03-2024, 13:31 PM
Last Post: ttkkas01
  scania dash adjust gskuvarega 1 99 20-03-2024, 04:51 AM
Last Post: sinigera
  Solved ✔ How to read Dash Fiat Ducato MahoJohn 6 195 19-03-2024, 08:56 AM
Last Post: MahoJohn
  Audi A3 2004 - VDO DASH scheme & pinout w/o password Yhoni 0 68 14-03-2024, 19:41 PM
Last Post: Yhoni
YTMercedes W906 dash with ------ temaindustriale 6 225 14-03-2024, 18:28 PM
Last Post: Gabriel87
ZVW Caddy 2007 PIN from dash eeprom Elijah 20 415 14-03-2024, 13:19 PM
Last Post: spacewalker
ZVW VW Sharan - Dash 7M3 920 840 N Pinout arturjfonseca 4 114 13-03-2024, 19:51 PM
Last Post: ady2006

Forum Jump:


Users browsing this thread:
1 Guest(s)

Return to TopReturn to Content