[JarsaR]

Just arrived yesterday, Better Cables than average. All New components...
Medium + i would Say. From Xcar360, 100925. 515$.

[xcar360]

Thanks , sir
it can update automatic on new version xods software
viktor and vitaly all test

[dodo34]

Where to get d14 HQ mux ?

[JarsaR]

Hey,

I made a small PDF solution, if your SDconnect multiplexer is dead, not powering up via any adapter cable. Easy to repair by yourself with this...

Regards,

-JarsaR

[tecnijl]

Hello,
someone can tell me if this C4 is of good quality.

---

this also plate C4 and wifi

[JarsaR]

Hello,
someone can tell me if this C4 is of good quality.

---

this also plate C4 and wifi

Looks good, but did you get this from seller...?

[pioan]

Epcos coil for can mising from pcb... so you need some rework first.

[dax635]

Hey,

I have a problem with 101044. Mux worked fine until it lost the CSD, I thought, no biggie, ill just update the software. But no go... The f cker disconnects and connects again, when i start the toolkit. Lan stays connected, if i wont start the Toolkit. When i try to update, it ends with error 748. I think i made this mess myself, when i tried to update, before the batteries were fully charged,(batteries could not be charged! ) Only update, it started to run was this 03_pmpic29_cpld13 update, but it ended prematurely and device only said, device is booting and got stuck after few reboots. After that, Lan started the connect/disconnect salsa. Anyone got this kind of a problem? I tried with another Lan PCB and cable also. Oh, and resetted to factory settings. What is that 03_pmpic29_cpld13 update?

Thanks
JarsaR.

Exactly the same situation here...

[JarsaR]

Hey,

I have a problem with 101044. Mux worked fine until it lost the CSD, I thought, no biggie, ill just update the software. But no go... The f cker disconnects and connects again, when i start the toolkit. Lan stays connected, if i wont start the Toolkit. When i try to update, it ends with error 748. I think i made this mess myself, when i tried to update, before the batteries were fully charged,(batteries could not be charged! ) Only update, it started to run was this 03_pmpic29_cpld13 update, but it ended prematurely and device only said, device is booting and got stuck after few reboots. After that, Lan started the connect/disconnect salsa. Anyone got this kind of a problem? I tried with another Lan PCB and cable also. Oh, and resetted to factory settings. What is that 03_pmpic29_cpld13 update?

Thanks
JarsaR.

Exactly the same situation here...

Yes, this is a faulty main PCB problem. I think no easy fix.

[brunocortona]

Could you reup please?

thank you

Hey,

Here is a firmware collection, OS:2.0, 2.2, & 2.3 and CSD`s suitable.