[Vacheron]

Hi, my wife had an accident with her Alfa MITO and the side airbags deployed.
Aside from the airbags hat else do I need to change? Sensor, ECU...etc?
Where is the airbag ecu located in order to remove it an read its eeprom?

Thanks in advance

[volavka]

Need reset AB ecu then change piece which exploded

[Vacheron]

Need reset AB ecu then change piece which exploded

Thanks
Can I reset the AB ECU with any diagnostic, or I should physically remove its eeprom and re-write it with a virgin dump?
Do I also need to replace the lateral sensor the initiated the airbag deployment?

Thanks again

[KRIS-CAR]

Hi
As the frontal cushions have opened you have to remove the AB driver located under the heater very close to the bulkhead wall, remove the two plastics at the beginning of the middle tunnel and you will see him.



IF I HELP Don`t forget to use Thanks button and reputation

[CHIKODIAG]

HI
whene you fond the your airbag unit post the information from label and we will tell you what you need to do
GOOD LUCK

[Vacheron]

According to car's VIN it should be 50518368 but I will make sure.
I also bought the multiecuscan interface. As soon as it arrives I will try to erase all errors an see how it goes. I will get back to you.

[Vacheron]

The elm interface arrived this morning and I just performed a diagnosis. There were same airbag related errors (you will see details in the following pictures) which I erased. Only 1 error persists...
I also include a screenshot from multiecuscan's airbag parameters.
The driver's pretensioner seems to have a fault but if you look at the it does not seem to be exploded and retracted...(looks exactly as the co-driver's side)
Any help as to how I should proceed is more then welcome