[DZEKI]

To take E60 tester, you need to roll back the firmware version 2013.3.0 ago. Put firmware 2013.2. Also check that you have the driver for usb and com port, and it is better to reinstall from the program.

[djscar]

For some bmw E60 and E90 you need to replace the diodes D701 and D703 for simple 1n4148

Try and report
Regards

[jmgameiro]

The last CDP+ I bought comes with new design diodes D701 and D703, after the color were white and now a kind of gold/red.
I think you need to replace just in boards where are no diode, just a liteli piece with 000.
I haven't try it yet on BMW E60.

[drumbo]

Replace two Capacitor on Si9241 Pin6 to 1nF (C5, C11).

[nexus_jose]

For some bmw E60 and E90 you need to replace the diodes D701 and D703 for simple 1n4148

Try and report
Regards

It is principal problem, change it

[nucar]

For some bmw E60 and E90 you need to replace the diodes D701 and D703 for simple 1n4148

Try and report
Regards

It is principal problem, change it

works fine!

[eddy159]

This is old china autocom problem.

[cristim]

For some bmw E60 and E90 you need to replace the diodes D701 and D703 for simple 1n4148

Try and report
Regards

i've done a few autocom/delphi in this way and all are working on e60/e65

[escape82]

Hi friends!
I've got a problem with my cdp+clone.
This is a 2 blue pcb version.
Earlier, it works fine with my Grande punto diesel electronic, but not work Man Tga ecus. i can read any more electronics, but not work some motor ecus.
In my punto works ABS, Inst, SRS, but the motor no.
I change D701 and D703 for normal 1n4148, test all of relays, but not work.
I can read Opel vectra 2000, suzuki wagonr 2000, but not a Peugeot 206 2001, fiesta 2006, and more...
Anyone has any idea?
Thanks

[FatMama]

Hi, recently we’ve purchased DS150E VCI (cloned Delphi) from autoobd2. On the picture below. What a piece of shit !!!
It cannot read BMWs or Merc cars. I replaced the diodes D701 and D703 for type 1n4148 , but it did not help . Lots of wasted. It could read Audi A4 (2008). The DVD supplied with the interface was also crap, couldn’t install . I had Delphi Release 3 ( 2014.2.2 ) from a different source, so installed that. Chinse supplier said that this is my software issue… I don’t think so .