[Gabriel130592]

Hello friends!

Try to read by OBD with MPPS v18 this car.
MPPS V18 could not read the ECU.
Then I dismantled the ECU and read it by BDM with Ktag.
I performed the EGR OFF and programmed it by BDM.
The car does not go beyond 3000rpm with EGR OFF or with ORI file.
I think MPPS V18 deletes the programming Injectors.
Are you programming the injectors of this ECU?
To program with Galletto via OBD
Do you have FULL BDM for this ECU?

CAR: Renault Scenic II
Engine: 1.9 dci (f9q) 120hp.
ECU: Bosch EDC16c3
HW/SW: 549-7.156

Attachment ORIGINAL BDM after trying to read with MPPS (no more than 3000rpm)

Thanks in advance!
Regards

[mike_service]

Its look like a Hodini job...upload dtc contempt from ecu !

[Gabriel130592]

The CAR no present DTC

[mike_service]

Check engine lamp are ON ?

[Gabriel130592]

No, check engine lamp off

[mike_service]

Write again original file in ecu ! should have one dtc stored for sure !

[Gabriel130592]

Hello friends.
As Mike told you the car did not have any trouble code in ECU.
I tried to program with Galletto v54 the programming of injectors by OBD (INYECTOR CODER CAN Renault) the file of another car (but other EDC16c3).
According to the programming, the car was going perfectly.
Then I pointed the nozzles reference and coded them with Autocom.

THE CAR IS PERFECT.

Apparently MPPS V18 had unconfigured the software of the injectors ....
And although he coded them with autocom he was missing part of the software.
Here I leave the file (INJECTOR CODER CAN) of another car that I programmed to solve the problem.
The same helps someone.

Thank you all!
Regards