[Pculvert]

Anyone know if you can do mileage correction on 2014-2015 BMW X5 using digiprog 4.94? Do I have to do by cluster or by module? Which vehicle do I pick on digiprog?
Thanks

[darek_naprawa]

Digiprog 4.94 will not do bmw f15.

[Pculvert]

Digiprog 4.94 will not do bmw f15.

Do you know which programmer will?

[eliaselias]

If it was cas4 you need to do cas and dash with vvdi prog
if it was with fem you can use can filter and have also to do dash

in both case digiprog can not erase original eeprom
so you can use vvdi prog or r270

[teerak2uk]

Blocker in cas r270 for dash

[pietje001]

X5 has fem

Canfilter in dash is easiest.
Remove battery First

[rs@chip]

Anyone know if you can do mileage correction on 2014-2015 BMW X5 using digiprog 4.94? Do I have to do by cluster or by module? Which vehicle do I pick on digiprog?
Thanks

with digiprog3 you can do only dash it have 35160 but better use r270 or any other 35xxx programer..for fem module you can find someone with bmw explorer to reset km to zero or use can filter..if you chose filter dont mount it to dash becouse you may have problems with it..instal it on directly on fem.good luck

[Pculvert]

Anyone know if you can do mileage correction on 2014-2015 BMW X5 using digiprog 4.94? Do I have to do by cluster or by module? Which vehicle do I pick on digiprog?
Thanks

with digiprog3 you can do only dash it have 35160 but better use r270 or any other 35xxx programer..for fem module you can find someone with bmw explorer to reset km to zero or use can filter..if you chose filter dont mount it to dash becouse you may have problems with it..instal it on directly on fem.good luck

Ok so do I need 2 filters? One for fem and one for dash?
Or do I just need one to reset both dash and gem? And what kinda software is needed if any?

[rs@chip]

Anyone know if you can do mileage correction on 2014-2015 BMW X5 using digiprog 4.94? Do I have to do by cluster or by module? Which vehicle do I pick on digiprog?
Thanks

with digiprog3 you can do only dash it have 35160 but better use r270 or any other 35xxx programer..for fem module you can find someone with bmw explorer to reset km to zero or use can filter..if you chose filter dont mount it to dash becouse you may have problems with it..instal it on directly on fem.good luck

Ok so do I need 2 filters? One for fem and one for dash?
Or do I just need one to reset both dash and gem? And what kinda software is needed if any?

only one filter is neded for block sinchronization..where you mount it is up to you, I yust give you advice to avoid problems with dash

[pietje001]

I always do in dash
Is easiest.

But before remove dash always disconnect battery