Unfortunately we do not accept new members for free, Now Registration cost 30€, if you are interesting Send Email to [email protected]
Alpina D5 Gearbox Software
02-10-2018, 10:19 AM,
(This post was last modified: 02-10-2018, 11:18 AM by F32_PiccoloPiccolo.)
Post: #225
|
|||
|
|||
RE: Alpina D5 Gearbox Software
I went ahead and flashed. All went smoothly meaning no errors in E-SYS. I reset adaptations values in ISTA and went for a drive. Gears were shown so I knew the flash was on.
BUT as I started to drive gears switchig abruptly and immediately. Upon doing 1st pull gear knocked and power was cut. Tried in all driving modes and same problem. Gear enters dead spot and is a no go. Thanks to Hulalans who just notified me my transmission is not compatible. Disappointed but my fault for not researching well enough. I am flashing back to original now and will test drive again. Thanks to all those who answered here. I reset the transmission adaption values in ISTA and now they all show up as 0mbar (clutch fill pressures) and 0.0ms under Rapid fill times. Even after having been for a drive. Is this bad? Out of these 2 I took the 1st option 1. Transmission Control Unit: Display and reset adaption values and 2. Transmission Control Unit: Reset Learning Function Any ways of bringing it back to the values it was populated before? Where does this come from or where are these set? |
|||
« Next Oldest | Next Newest »
|
Users browsing this thread:
1 Guest(s)
1 Guest(s)
Return to TopReturn to Content