[iyade46]

F30 2016 ista/p error please help ista/p cant acces the car i use enet i dont know what is the problem

[Bimmer540]

Enet-cable is very dangerous to use! Use Icom...

[PopDog]

Set Network Card where E-Net is plugged in to
IP: 169.254.1.1
Netmask: 255.255.0.0

Start Ista-P Loader -> E-Net Emulator wants ZGW IP -> look it up with C:\EDIABAS\Hardware\ENET\ZGW_SEARCH.exe

Start Ista-P and open Settings
In Setting you can set E-Net Direct Connection and Enter Direct IP of ZGW
(lookup ZGW IP with C:\EDIABAS\Hardware\ENET\ZGW_SEARCH.exe) same as before

I've done this with an F30 2012 Modell and everything got updated except Kombi / HU/Rad AMPT. For Kombi and HU you can use E-Sys. There is some solution with DHCP Server Program for ICOM to Flash with them with ISTA-P but I think it is not working with E-Net.

Try first with this connection. If Kombi and HU failes, you can try this manual with e-net and ista-p. Please Report when it is working LINK

[Shinoby]

F30 2016 ista/p error please help ista/p cant acces the car i use enet i dont know what is the problem

Configure Ediabas for ENET cable.

---

Enet-cable is very dangerous to use! Use Icom...

[iyade46]

Set Network Card where E-Net is plugged in to
IP: 169.254.1.1
Netmask: 255.255.0.0

Start Ista-P Loader -> E-Net Emulator wants ZGW IP -> look it up with C:\EDIABAS\Hardware\ENET\ZGW_SEARCH.exe

Start Ista-P and open Settings
In Setting you can set E-Net Direct Connection and Enter Direct IP of ZGW
(lookup ZGW IP with C:\EDIABAS\Hardware\ENET\ZGW_SEARCH.exe) same as before

I've done this with an F30 2012 Modell and everything got updated except Kombi / HU/Rad AMPT. For Kombi and HU you can use E-Sys. There is some solution with DHCP Server Program for ICOM to Flash with them with ISTA-P but I think it is not working with E-Net.

Try first with this connection. If Kombi and HU failes, you can try this manual with e-net and ista-p. Please Report when it is working LINK

work very fine ISTA/P can see that car and take VO but another problem is the program can only acces the FEM module and cant see any other ecu !!
i use ista P up to 2017 working fine and ista D can contact all the modules so what the problem can be please?