[REPRO]

After changing km the car at startup but not picking up, error dme 4A42 but already tried to sync with fvdi cas-dme but does not let sync, someone can see the eprom and flash if they are correct were read with x-prom.thanks

[Remap Ross]

Does it work OK if you put original back on?
Also this is in chip tuning section to make you aware

[volavka]

The eeprom is fine

Probably Flash data corrupted while reading
Look for flash format xprog,rosfar or anything else and write in Cas

Ps. Flash dump shoud be same as Cas HW/SW No.

Here Your full Cas data info if needed

VIN: WBANC91010B765171
DME Code: 00000F75
Odometer: 289275 km
Key Type: E60 old type
Mechanical Code: 1878
Remote Frequency: 868MHz
Used keys: 1,2,3,5

Good luck

[ricco]

After changing km the car at startup but not picking up, error dme 4A42 but already tried to sync with fvdi cas-dme but does not let sync, someone can see the eprom and flash if they are correct were read with x-prom.thanks

Try to sync with ignition off and key out of the key slot.