[volavka]

Here Tested immo off solution for fenix5 ,

1. you find position flash and remove gum and don't take out flash.
   

2. add Power suply +12V to Pin 24 & 32 and GND to Pin 2 & 3
   
you need an 12/5W probe lamp conected to Pin 43 and second terminal to +12V so the probe lamp must be blinking

first cut immo wire to ecu.Pin 37 use the light on dash (engine mngt not red led) for blinking ref.



3 one side of the flash is A side the other b side (lets say)

you have 9 pins either side,so 9 on A and 9 on B, short 1A with 1B then 2A with 2B all the way till 9A and 9B.(look image above ) holding each for at least 2 secs, engine mngt light should go out,car will then start.

NOTE: you may have to do it more than once before light goes out

If your mngt lamp stops blinkig ecu erase memory tms OK

cut Immo pin ( number 37) and mount ecu in car and Start


Best Regards

[ROD-BENDERS]

Here Tested immo off solution for fenix5 ,

1. you find position flash and remove gum and don't take out flash.


2. add Power suply +12V to Pin 24 & 32 and GND to Pin 2 & 3

you need an 12/5W probe lamp conected to Pin 43 and second terminal to +12V so the probe lamp must be blinking

first cut immo wire to ecu.Pin 37 use the light on dash (engine mngt not red led) for blinking ref.



3 one side of the flash is A side the other b side (lets say)

you have 9 pins either side,so 9 on A and 9 on B, short 1A with 1B then 2A with 2B all the way till 9A and 9B.(look image above ) holding each for at least 2 secs, engine mngt light should go out,car will then start.

NOTE: you may have to do it more than once before light goes out

If your mngt lamp stops blinkig ecu erase memory tms OK

cut Immo pin ( number 37) and mount ecu in car and Start


Best Regards

Master class