[Bimmer540]

Ista 4.08 problem with E-series. Fxx works perfect.


From Ista 4.08 I have a problem with E-series incl K+Dcan cable and with Icom.


When I start procedure it reads vin etc but after that is hangs on "see picture" and after a while it goes trough.


With Icom it takes 2min to go trough this message.

With K+Dcan and without NodeEdiabasVoltageControl V3 it takes 3min to go trough this message.

With K+Dcan and with NodeEdiabasVoltageControl V3 it takes 5min to go trough this message.



This ABL-GES function was not in 4.07 and that works without any problems with Exx and Fxx with Icom and K+Dcan cable .


Is it possible to get rid of this message like FASTA!!

[atomantmk]

I don't have a problem with the new version, it work like a charm.

Gesendet von meinem SM-T585 mit Tapatalk

[Bimmer540]

I don't have a problem with the new version, it work like a charm.

Gesendet von meinem SM-T585 mit Tapatalk

Do you also have BLP in registry?

[atomantmk]

Do you also have BLP in registry?

[Bimmer540]

Do you also have BLP in registry?

Have you tride it on Exx? With Icom an K+Dcan?

[atomantmk]

Yesterday with ICOM Next and everything was fine.

Gesendet von meinem HTC 10 mit Tapatalk

[Bimmer540]

Yesterday with ICOM Next and everything was fine.

Gesendet von meinem HTC 10 mit Tapatalk

Can you post your ISTAGUI.exe

And canyou post picture from:

[HKEY_LOCAL_MACHINE\SOFTWARE\WOW6432Node\BMWGroup\ISPI\Rheingold]

[atomantmk]

[Bimmer540]

Thanks. Do you have K+Dcan cable that you can try.

Sorry I need ISTAGUI.exe.config

[atomantmk]

I have never used K+DCan cable, with ISTA I'm using only ICOM.

Gesendet von meinem HTC 10 mit Tapatalk