[Emmy]

My CAN bridge is self made with IR remote to switch on/off, louder/quiter...
It´s an Arduino Uno R3 with Seed Studio CAN shield and self programmed software, plugged to a ZGW2 and all powered by a 12V 3A power supply.
(google will help with this hardware)

nice work.
can you sell me programmed Arduino Uno R3? you can write your price via pm.

[EdgaBMW]

Yes, E-models and F-models have different bus speeds and physical layers.

F-models have 500 kb/s, high speed CAN with 0-2.5 and 2.5-5 V range and need
ID 130 with length 5 and {69, 241, 252, 255, 255, 0, 0, 0} (not HEX) every 500-1000 ms
ID 12F with length 8 and {140, 80, 138, 221, 244, 5, 48, 6} (not HEX) every 500-1000 ms

E-model have 100 kb/s, low speed CAN with 0-5 V range and need
...I actually can´t find, I send it later

If someone needs a program for an Arduino with CAN shield, I wrote a program for it, including a part for infrared remote to switch it on or off or louder, and so on. But for E-models there is no CAN shield ready to buy, that has to be soldered and has different software. So if someone needs it for F or E models, no problem.

if i set 500 or 1000ms ignition is randomly goes on and off. Maybe can you help me with that? Wake-up wire must be connected to 12V?

Thanks

[ElBarto]

Hi, I have seeed arduino can bus shield v2.0. Someone can share source with me ?
I want to wakeup ZGW and KOMBI on bench.