Unfortunately we do not accept new members for free, Now Registration cost 30€, if you are interesting Send Email to [email protected]
2009 Nissan Rogue No CAN communication with ECM, TCM, ABS
06-01-2018, 09:24 AM,
(This post was last modified: 06-01-2018, 09:24 AM by xtac1080.)
Post: #1
|
|||
|
|||
2009 Nissan Rogue No CAN communication with ECM, TCM, ABS
Hello all.
I have a no crank 09 Rogue sitting at my shop with no communication to the ECM, TCM, or ABS. I can communicate with all other CAN modules except for those 3 (they throw U-codes, U0101 & U1001). I thought it was a K-line fault at first, but the TCM is not on it. I've checked power/ground to all modules and they are good. None of my schematics show where the CAN line splices. I assume there is a single twisted pair that runs between the inside and engine bay to perhaps a splice or junction block, though I could be wrong. I'd rather not rip the entire harness apart to track it down. Anyone know where the CAN lines to these 3 modules join together? I imagine it is corroded/cut/pinched. |
|||
« Next Oldest | Next Newest »
|
Users browsing this thread:
1 Guest(s)
1 Guest(s)
Return to TopReturn to Content