Unfortunately we do not accept new members for free, Now Registration cost 30€, if you are interesting Send Email to [email protected]
Carprog easy tutorial flashing
08-03-2018, 22:23 PM,
Post: #1
|
|||
|
|||
Carprog easy tutorial flashing
Hi.I did all the tutorials regarding the flashing of the carprog but all was not clear. I tried the method that I posted to you. It is functional, I just simplified and modify the flashing procedure for that it is simple for the novices (I am one myself). I did not invent anything or create, I just observed and tested the different methods in order to arrive at something simple steps.
1) No need to unsolder AT88SC. 2) no need to lift pin 55 or solder a wire on the pin 55 (according pcp) . 3) the reset is done on a single pin as in the photo. 4) photos of the connector that I made. I did not put you the flashing procedure with bin,lib and soft(there is a lot of post on this subject). I use the segger software "flash V 4.98" and of course the segger interface jlink . PS look at the photos and make sure you have the same pcb.have a good flashing. if you have any questions, do not hesitate. If it has been useful press thank you NO PASS FOR ALL MEMBERS |