[benq222]

Hey there,

I'm trying to adjust the milage of a Clio 2.
I removed the dashboard from the car and want to disassemble it (looking for a 93C46).

I'm not 100% sure if i can get rid of the needles by just pulling them off - how do i continue dismantling the dash to read the chip?
Check the attachment

regards

Tim

[drewdoom]

Hi.Here is screnshot from NYO maybe can help you if this is that one dash.

[benq222]

Thanks for the reply!

I continued dismantling - this is the board.
As far as i figured this out i got the "Sagem NEC" - seems like there is no "easy" read/write onclip - is this correct?

Any other easy & fast way to modify the km?

I added two pictures.

Regards

Tim

[pawel7924]

Thanks for the reply!

I continued dismantling - this is the board.
As far as i figured this out i got the "Sagem NEC" - seems like there is no "easy" read/write onclip - is this correct?

Any other easy & fast way to modify the km?

I added two pictures.

Regards

Tim

You must connect NEC programer direct to dashboard ... (DIGIPROG, DIGIMASTER), or use Digiconsult method ... exchange Oscilator and use 46MHz generator to make mileage what you want ... I think first one will be easier to make ... Only 2 wires you must connect directly to chip (one pin you must separate from the board) ... the rest of wires are conected to dashboard points ... if you have nec programmer i can send you manual how to connect wires ...

Best reg Pawel

[benq222]

Unfortunately i just have a serial eeprom programmer