[Zamperl]

Hi mate,
I got a tune from a member of this forum.
Stage1 + EGR off (DPF on, because it's still there).
The consumption is less than before, the stage 1 is ok.

Sometimes the motor can't start immediately because of starter problem. I wanted to verify its DTC (got it before with the *.ori) but nothing was stored.
I believe that all DTCs are away = 0.

Could you please rate (verify) my tune?

MbSprinter218Cdi_EDC16+CP31-36_SW1037381134.zip
File Type:
Downloaded:	13 times
Size:	68.16 KB

MbSprinter218Cdi_EDC16+CP31-36_SW1037381134_Stage1-EgrOff.zip
File Type:
Downloaded:	14 times
Size:	68.2 KB

[ltujustas]

Hi mate,
I got a tune from a member of this forum.
Stage1 + EGR off (DPF on, because it's still there).
The consumption is less than before, the stage 1 is ok.

Sometimes the motor can't start immediately because of starter problem. I wanted to verify its DTC (got it before with the *.ori) but nothing was stored.
I believe that all DTCs are away = 0.

Could you please rate (verify) my tune?

Disconnect maf and than check errors

[Zamperl]

Why do I need to remove the mass flow sensor? For what? Just to see an error? Ok, then I'm going to follow it.
What is wrong with the tuned file comparing with the ori file? Anything wrong?

[mysterious]

Same stage and egr off with all DTC on if you need

[Zamperl]

Thanks mate, I'll try it and report.
Should be switched off (set to 0) the EGR related DTCs?

[mysterious]

Thanks mate, I'll try it and report.
Should be switched off (set to 0) the EGR related DTCs?

All DTC is on and egr. Here file with same stage, egr off and the just EGR related DTC OFF.
Good luck