[obdstart]

Here:
http://cartechnology.co.uk/showthread.php?tid=18857

[Gammapooka]

VCDS Lite Isn't working.
Says it's registered but i can't change any setting(s)

[Drunkdriver]

Same goes for me, it says i need to register and i can't do anything else than the free version.

[Drunkdriver]

I got it to work by exit after the test and plugging the interface in and out. Thanks!

[Piklz]

Tested and confirmed application works, well at least part works for me. However this seems more likely to do with either the cable I'm using or some previous modifications I have had done to the car itself (things others may need to consider).

To help clarify - Installed program, set/test cable/port in program. At this stage program equal to freeware, this can be checked by clicking the about button, status software needs to be tested on car. Go to select control module > engine controller > check fault codes & ignoring what ever codes you may have gotten now go back to about button - status now shows full reg. This than can be confirmed by going back to cont mod >engine > measure blocks. If you can get a reading with 'ANY GROUP' after 025 (which the limit for the free version) the registration worked.

note - not all groups will or should have a response reading, check with rosstech or online for valid group numbers

I can now access groups past 025 and other functions previously could not, however on some of these for me I can get a reading but particular signal is erroneous. Which in my case is an issue with my ecu or cable not program.

Hope that help clarify, thanks for hosting legit copy.

[kevin015]

This works and is full version,im using with cheap ebay cable,just get drivers for it and this lets you change auto door locks,thanks for posting down load link

[LukeyBabes]

I can also confirm this works and is activated. Just need to test on a car for it to activate.

[Trigger1002]

Thanks, works perfectly for me too

[sabelt]

It works perfect! Fully auto scan, logs etc. Thanks!

[psomi]

Hi to all! I have a problem with the program. when I choose the engine01
a window appears that says the following "too many communication errors to continue" I made some efforts such as changing usb but the problem remains
I have the blue cable kkl and I use the COM4.
Ηas someone the same problem?


Thanks in advance