[atomantmk]

Car is pre LCI from 2004 with VO S522A Xenon Light and S524A Adaptive Headlights, I have changed back lights with LCI and LM2 AHL 9203081 but on the right side angel eye don't work.

Car is VO coded but question is, do I must to make with wires from pin to pin or some coding can do the job?
Here is TRC file from LM2 AHL.

[dumitru.o]

Cars before 09/06 only.
Install light module T.

For all cars.
Dismantle plug X12 from the light module and reconnect
the cables as follows:
– pin 25, GR/GN, to pin 63
– pin 40, GR/BL, to pin 11

[atomantmk]

Cars before 09/06 only.
Install light module T.

For all cars.
Dismantle plug X12 from the light module and reconnect
the cables as follows:
– pin 25, GR/GN, to pin 63
– pin 40, GR/BL, to pin 11

I have this light module.

[dumitru.o]

good. go to the next step and move the 2 wires

[Mwahab]

When you use LM2 with LCI taillights and PreLCI headlights, you need to change this value after VO Coding with LCI date

PWM_ANSTEUERUNG_RL_BL
Werte_02

[JaVlk]

hello, I have a BMW e61 prelci 2004 and I made front and rear lights from lci but I still can't get Adaptive Headlights, what do I have to code in lm2

[atomantmk]

Did you add $524 to VO?
Check the wiring?

[kn6600]

hello, I have a BMW e61 prelci 2004 and I made front and rear lights from lci but I still can't get Adaptive Headlights, what do I have to code in lm2

Pre-LCI have AHL module for adaptive headlights.
LCI don't have AHL module , this module is integrated in LM2.

[NeRkO20]

hello, I have a BMW e61 prelci 2004 and I made front and rear lights from lci but I still can't get Adaptive Headlights, what do I have to code in lm2

you have to unpin the AHL Module (passenger side) and pin the wires directly into LM2

AHL --> PIN2 --> PIN38 LM2
AHL --> PIN3 --> PIN37 LM2
AHL --> PIN5 --> PIN27 LM2
AHL --> PIN6 --> PIN7  LM2
AHL --> PIN8 --> PIN55 LM2
AHL --> PIN9 --> PIN54 LM2
AHL --> PIN15 --> PIN66 LM2
AHL --> PIN16 --> PIN46 LM2
AHL --> PIN17 --> PIN76 LM2
AHL --> PIN18 --> PIN75 LM2

and also PT-CAN

AHL --> PIN13 --> PIN71 LM2
AHL --> PIN14 --> PIN72 LM2

Change TimeCriteria to #0307 (temporary) and code LM2 or to #0308 then you will have variable light distribution if you wish

And you need SMC2 Modules for adaptive....can´t use the SMC1 form pre-LCI adaptive hedalight

The pinning above is ONLY if you have pre-LCI WITH AHL and then you retrofitted to LCI WITH AHL...

[JaVlk]

hi, thank you for the message, I have predlici and I was putting lights from lci new smc2, I have it too, I will try it