Unfortunately we do not accept new members for free, Now Registration cost 30€, if you are interesting Send Email to [email protected]
ford IDS error code 7 - 0x23 851082
18-01-2019, 13:27 PM,
Post: #1
|
|||
|
|||
ford IDS error code 7 - 0x23 851082
Hi,
Ford Mondeo 2001, 2.0 Duratec HE, Automatic Trying to flash the PCM with a VCM2. It gets to about 25% roughly on the progress bar then displays this error, error code 7 - 0x23 851082 OLd calibration was 1S7F-12A650-DAD New 1S7F-12A650-DAF Doing it because when identifying the PCM IDS said it was mandary to update. Can’t find out what error code means other than the last bit 851082 is some kind of timeout. Thanks |
|||
19-01-2019, 18:20 PM,
Post: #2
|
|||
|
|||
RE: ford IDS error code 7 - 0x23 851082
Use VCM I, it will work.
|
|||
25-01-2019, 17:36 PM,
Post: #3
|
|||
|
|||
RE: ford IDS error code 7 - 0x23 851082
Check the FEPS (Flash Eprom Programming Signal) voltage on OBD pin 13, it must 18-19 Volt.
That's a common problem with a lot of cloned interfaces and programming. |
|||
28-01-2019, 20:51 PM,
Post: #4
|
|||
|
|||
RE: ford IDS error code 7 - 0x23 851082
which version of IDS you use ? to me worked with v 98 up / ford mondeo mk3 tdci 2004
v 86 ...v96 they did not offer 18 volt on pin 13 FEPS voltage is a Ford way to initiate flash programming by sending 18 volts to PCM via pin 13 of diagnostic connector. This signal is only coming from VCM during flash erasing/programming. |
|||
25-08-2019, 06:08 AM,
Post: #5
|
|||
|
|||
RE: ford IDS error code 7 - 0x23 851082
Is this voltage on pin 13 comes and goes with certain pattern or can I just add external 18 v to initialize programming mode?
|
|||
« Next Oldest | Next Newest »
|
Users browsing this thread:
1 Guest(s)
1 Guest(s)
Return to TopReturn to Content