[willisodhiambo]

I want to replace an msv80.1 in x3 2.5i with another. Car has ews 4.4. My tools are all cas tools. I have read msv dme isn and i get 128bit isn. Ews isn is 2 bit, 4 digit. I attempted to read old dme isn but it has a can fault. That is why am replacing it.

I think msv80.1 for ews may have isn at a different address compared to cas msv80. Is thare any way i can resolve this? Reading new msv80 dump is a pain. I need resistors soldered on but i have no idea what size of resistor. I only have ohm classification of resistor. Nothing on resistor voltage or amperage. Any ideas?

Any way i can figure the 4 digit isn from 128bit read from dme?

---------------------------------------------------------------

MSV80 ISN is long in EWS. Problem solved. We learn all the time

[Aimanad_101]

I highly advice before practicing and learning on customers cars go and learn how this work.
Because i see u mixing things together..
There is small software that easily show u isn from ews4 and can change it.

[lustek]

Hi,

try to use ews editor. it show isn

[willisodhiambo]

I have the ews software. Already read ews dump and i need to change the isn. The problem is that when i read dme isn i get long isn!! Am using yanhua mini. If i can figure out short isn from dme i should be good to go.

---

Hi,

try to use ews editor. it show isn

I already have ews dump and ISN, what I need to figure out is short isn from DME. I get long ISN when I read it with my tools.

[Aimanad_101]

Hi,

try to use ews editor. it show isn

for ews 4 different software with converter option as i remember with (shift+p or similar function not remember exactly) or just do it manually