[chong5195]

HI.. i has bmw e60 n52 engine  the car is cranking but not start .. here is the fault code... can anyone make sure what is the fault... cranksensor ????

[rana]

timing problem need to check the timing with tools

[Willinickersen]

HI.. i has bmw e60 n52 engine  the car is cranking but not start .. here is the fault code... can anyone make sure what is the fault... cranksensor ????

The code yep you what is wrong..it may be VANOS solenoid or camshaft sensors .. 
Clear the error codes, swap the sensors, then see if the error code follows the bad sensor. if it does, replace the sensor.If the code recurs on the inlet side after swapping sensors, clean the vanos solenoids and swap them. if the error recurs and follows the inlet solenoid, replace the solenoid.

[chong5195]

Maybe is crankshaft sensor..because no fire at sparkplug..i try replace first

[Willinickersen]

Do what you feel like, I only write as I've experience those years

[chong5195]

Do what you feel like, I only write as I've experience those years

ok thnak mate... try fisrt

[Node]

Its up to you what you do but checking crankshaft sensor is elementary. Look at rpms using live values and crank with starter. If you see something around 100+-50, then its ok. But if you prefer changing half a car to find an issue - its up to you.

[chong5195]

i using scanner go to datalist rmp not runing .... went i start the car

[RYM6746]

Clear the fault codes and simply unplug inlet camshaft sensor. Then crank it im pretty sure it will log a completely different camshaft sensor fault code it will also not be able to tell if the valve timing is out and may try to fire the spark plugs

[LBDT]

what are the CAS errors?

for vanos try to reset adaptations and clear errors then check again, it may dont do nothing but you never know...