[zizzou]

Hello there

For those who have a Chinese Can clip that remain stuck at 20% on the update of the firmware here is the procedure to stop the worries and can again use the Clip device.

Must rename the following files:
C: \ CLIP \ DATA \ APPLI \ PARAMS \ appliiso.s19 in appliiso.bak
C: \ CLIP \ DATA \ APPLI \ PARAMS \ applican.s19 in applican.bak

Voila, it's easy as pie but I know some appreciate to have this solution.


click thanks and ruputation 653653653653



tested by my self work 100%

[reda75]

TESTED WORK 100%

[baner]

Hello there

For those who have a Chinese Can clip that remain stuck at 20% on the update of the firmware here is the procedure to stop the worries and can again use the Clip device.

Must rename the following files:
C: \ CLIP \ DATA \ APPLI \ PARAMS \ appliiso.s19 in appliiso.bak
C: \ CLIP \ DATA \ APPLI \ PARAMS \ applican.s19 in applican.bak

Voila, it's easy as pie but I know some appreciate to have this solution.


click thanks and ruputation 653653653653



tested by my self work 100%

Hmmm, this is a very very old trick, that in fact just "mask" problem with firmware update, but if you try your CLIP fixed on that way on real diagnostic on car, especially on newer RENAULTs, you'll find that this solution *does not work*, so essentialy problem with 20% is HARDWARE problem and require HARDWARE, not sofware, fix like this one.


Regards!

[cubica]

Unfortnately, @baner has a right hw is problem, no sw

cuby

[racin-snake]

Some units with iso light not working come back to life and show can and iso led's and actually work after using new software without patch and use key generator instead

it came as a surprise when i used an old thought to be broken interface to test software to update i have seen 2 be revived after this procedure of using newer software with no patch

so there must be some software issues that directly affect the hardware this only being one i found albeit by mistake

[Romi33]

Guys the "20% problem" on China CLIPs is related somehow with the power supply of the probe. Don't know details, just that the power supply has to be very stable, from car and from the notebook too. The best way how to solve it is to connect the probe through an externally powered USB hub (notebook - hub - probe). It will work 100%

[blck]

+ sometimes you have to check the USB drivers. If there is USB 3.0 it would affect the probe

[nokia35]

+ sometimes you have to check the USB drivers. If there is USB 3.0 it would affect the probe

yes thank you it work verry well

[yokoicch]

TESTED WORK 100%

THANKS 1000%

[donjuan020]

Some units with iso light not working come back to life and show can and iso led's and actually work after using new software without patch and use key generator instead

it came as a surprise when i used an old thought to be broken interface to test software to update i have seen 2 be revived after this procedure of using newer software with no patch

so there must be some software issues that directly affect the hardware this only being one i found albeit by mistake

How to make it. I dont use can clip. dont Update framework stop. Please help me.