[peoe]

Looking for help/guidance with resolving an issue.

I updated VSGG83 ECU on E83 using WinKFP and K-DCAN, now I am seeing ABS, Brake and 4x4 lights on dashboard. Car drives fine.

ISTA+ says there is a coding error so I installed ISTA-P 3.66.1 with 6.1F loader with hope to do the coding there. Unfortunately I can't seem to connect even with ICOM emulator activated. 

Thoughts:
- INPA doesn't have a job list option for E83 so I don't have the list of modules. I picked the highest ZB-Number 7599883 to flash in WinKFP, could that be an issue or would any ZB-Number work? I assumed higher is better.
- In ISTA-P Loader I went through installing patched EDIABAS 7.3 + run K-DCAN network config tool. Still no connection with K-DCAN cable.
- VTG module status in INPA+ sometimes shows module grey, sometimes orange. Doing ECU tests tells me ECU is working properly.

What do you recommend I do next?

Some screenshots attached.

[jaramillo]

Perform coding via NCSexpert

[peoe]

Thank you jaramillo. Everything is good now.