Unfortunately we do not accept new members for free, Now Registration cost 30€, if you are interesting Send Email to [email protected]
Solved ✔ Unable to read me 9.2.1
19-03-2022, 03:23 AM,
(This post was last modified: 20-03-2022, 23:32 PM by Clusters.)
Post: #1
|
|||
|
|||
Unable to read me 9.2.1
Hello,
I am trying to connect to a Bosch Me9.2.1 (attached is the exact part number) dme over can using the diagram attached below however Inpa will not communicate with dme. I get the error no response from control unit. I have tried to read using dcan and Kline. I have tested with two DMEs same result. I know it’s the not cable since this method works with MSD80 no problem. Any idea on why this will not work? |
|||
19-03-2022, 07:18 AM,
Post: #2
|
|||
|
|||
RE: Unable to read me 9.2.1
you cant connect like that
check the wiring digram and look for the wire which go to OBD2 pin 7 or pin8 then you will know what to do and how to check |
|||
19-03-2022, 07:37 AM,
Post: #3
|
|||
|
|||
RE: Unable to read me 9.2.1
Remember the different CAN buses. D-CAN is not the same as PT-CAN.
For using EDIABAS / INPA / ISTA you need a gateway and D-CAN (= Diagnosis CAN). Your connection scheme show PT-CAN (= PowerTrain CAN). I think it is for using with BMW Explorer or something similar. |
|||
19-03-2022, 11:32 AM,
Post: #4
|
|||
|
|||
RE: Unable to read me 9.2.1
120 ohm resistor between can high and can low install try
|
|||
19-03-2022, 11:57 AM,
Post: #5
|
|||
|
|||
RE: Unable to read me 9.2.1
(19-03-2022, 07:37 AM)Spitfire555 Wrote: Remember the different CAN buses. D-CAN is not the same as PT-CAN. Understood but why can I connect to a MSD80 this way? And why does not Kline work this way either? I have done this with other dmes no issue at all! |
|||
19-03-2022, 13:20 PM,
Post: #6
|
|||
|
|||
RE: Unable to read me 9.2.1
|
|||
20-03-2022, 06:32 AM,
Post: #7
|
|||
|
|||
RE: Unable to read me 9.2.1
send the car vin i will help you
|
|||
20-03-2022, 07:40 AM,
Post: #8
|
|||
|
|||
RE: Unable to read me 9.2.1
Hier pinot for me9.2
BR EDDY immo daten transfer
cas dump reparatur cvn fix No help for people not give a feedback |
|||
Reputation: +1 - egoy936 [+1] | |||
20-03-2022, 22:16 PM,
Post: #9
|
|||
|
|||
RE: Unable to read me 9.2.1
Solved! The picture Eddy posted allowed me to read and flash the DME with winkfp!
|
|||
« Next Oldest | Next Newest »
|
Users browsing this thread:
1 Guest(s)
1 Guest(s)
Return to TopReturn to Content