[nokia35]

Hi,

I was wondering if a Nissan Consult III hardware works with Renault CAN CLIP (v139 for example)?
This is the Consult III I'm talking about (Chinese clone)




And if yes.. Will it support reprogramming, etc..? And is it recommended over SONDE as it has the newer Alliance PCB..

i think you can not use the can clip software for nissan consult3
it give a special software for nissan concult 3

[pb1234]

Does anyone sell original HW Consult3 (not a clone)? Or you can advise where to buy really good clone? In the photo,, A,, is good clone. In the photo,, B,, is already low quality version. Does anyone know where to buy exactly the same hardware as the picture,, A,,?
However, if someone sells original HW Consult3, so it interests me the most.
Thanks for any help and sorry for bad English.

[alfabit]

You can buy also a chinese clone ( alliance consult3, CAN-clip sonde ) there are not so bad people say... Latest years chinese make better and better tools, anyhow 90% electronic goods are chinese made ( look the back of your TV set and you will see for sure " Made in China " )
And yes, Alliance 3 works with CAN -clip software, even the Reno-Nissan representatives work with CAN-Clip sonde and Alliance 3 with the same laptop on CAN-Clip software.
And yes, they also use chinese clones ( Alliance and CAN-Clip sonde ), no one else manufacturing these hardware tools but the chinese.

[obdtool]

Hi,

I was wondering if a Nissan Consult III hardware works with Renault CAN CLIP (v139 for example)?
This is the Consult III I'm talking about (Chinese clone)




And if yes.. Will it support reprogramming, etc..? And is it recommended over SONDE as it has the newer Alliance PCB..

Consult 3 and CAN CLIP Use the same hardware - here
Renault can clip hardware is good for nissan consult software,it is able to diagnose nissan cars with renaul can clip hardware!!! (sp19-b and sp38-b)
very well and cheaper

[DOWNLOADIX]

1： the clone of nissan consult 3 VI from China is not the 100% copy, It's only have a C3 cover, so if you want use it you must make a software patch to instant the original driver of C3
2: In China the dealer of Renault is use the NISSAN C3 for an offical origianl diagnostic tool.
So if you have an original c3 you can use it for Renault CANCLIP ,But if you have a clone one, you should make a patch at first,then you must test it by youself.

[Mohamed.Ar]

Does anyone sell original HW Consult3 (not a clone)? Or you can advise where to buy really good clone? In the photo,, A,, is good clone. In the photo,, B,, is already low quality version. Does anyone know where to buy exactly the same hardware as the picture,, A,,?
However, if someone sells original HW Consult3, so it interests me the most.
Thanks for any help and sorry for bad English.

hi Friend
i have a Clone like pic B
if i chanche that chips cyrcled in red like the pic A
Does my consult 3 will be good than before ....???
i have a probleme it disconnect a lot when diagnosizing cars ....
is there a solution for this ...???

Envoyé de mon SM-N9005