[oskapage]

I have with a defective EEPROM (93C86). I soldered it out put it in the programmer and it actually can't be programmed . Is it systemically programmed in its entirety or just from some address ? Is replacing it with a new one enough before programming the module or do you have to look bin ?

If necessary does anyone have and could share ?

R1200GS 08-2008
Part
65758544716
65758535346
65758532947
65758521794
65757723483
65757722092
65757720240
65757718057
65757713340

[TheNine90]

Can you read the eeprom?

[oskapage]

Each time the reading is different , I decided it was defective . As I put in the programmer fresh give write and read also ruled out his . From this started ISTA/P could not reprogram it .

[Vojno]

I only have one older than these.
6575 7 697 695 and it has 93C66 eep!

[oskapage]

Vojno thank you very much for your reply , I see your activity , I read a lot .

6575 7 697 695 this is the DWA only version without RDC . I can't tell if this memory is responsible only for DWA , somewhere must also sit information about TPSM . Today I bought a used DWA/RDC module I took out the EEPROM , it read beautifully . I will immediately make a copy on a fresh EEPROM for the old module . I will see if the module will come to life . I could insert the one bought , reprogram and code but . TWO are the only modules that complicate my life when programming and I already have several . I don't know if the location at the back of the motorcycle which is exposed to shocks causes this , or just the poor quality of them ? Tomorrow I will let you know if the operation was successful

[bearheroes]

this should work...