[dankocg]

Do we have an expert who can help with removing errors that appear on the board and on the nbt display after turning off the xdrive system with the esys tool? I did the fdl coding procedure in DSC2 > 3000 > C_Funktion_LaengsMomentVerteilung_nicht_aktiv but the errors are there that the system is faulty even though everything is working. Did any of the experts deal with coding so that the errors disappear after coding with esys and can you share that?My Car is BMW F10 525xd from 2016year.

Thanks

[budddyyy]

https://cartechnology.co.uk/showthread.p...#pid608856

here is a good example how its work. maybe on f10 little bit different, but it seems it is possible.

[dankocg]

i will try and raport…

[dankocg]

i try but i still have error in the dash and nbt display…

[SkeYT]

In DSC change parameters:

Variante_Antrieb
Allrad (01) -----> Heck (00)

Funktion_LaengsMomentVerteilung_aktiv
aktiv (01) -----> nicht_aktiv (00)

Funktion_HillDecentControl_aktiv
aktiv_kmh (01) -----> nicht_aktiv (00)

Funktion_LMV_FestBremsSchutz_aktiv
aktiv (01) -----> nicht_aktiv (00)

Funktion_LMV_KupplungsSchlupfAbbau_aktiv
aktiv (01) -----> nicht_aktiv (00)

Funktion_LMV_HarterSchutzEingriff_aktiv
aktiv (01) -----> nicht_aktiv (00)

Funktion_LMV_MomentenabsenkungSegeln_aktiv
aktiv (01) -----> nicht_aktiv (00)

---------------------------------------------------------

In ICM change parameters:

IcmKod_B_S203A
verbaut (01) -----> nich_verbaut (00)

IcmKod_B_HLenInIcm
verbaut (01) -----> nich_verbaut (00)

C_HDC_vorhanden (C HDC present)
ein (01) -----> aus (00)

--------------------------------------------------------

In EGS change parameters:

Allrad (All-wheel drive)
aktiv (01) -----> nicht_aktiv (00)

Now remove both fuses feeded VTG module and clear CAN adaptation and Rear Axle in EGS and car must go sleep. After that clear all errors and you have fully RWD. Have fun.

[dankocg]

This is work no error in the dash

Only error when scan with bimmerlink is this:

Digital Disel Electronic

CD952A Message (ST_REPAT_XTRQ_FTAX_BAX, 19.3.4, FX): Message from LMV (longitudinal torque distribution) failed

and i can not delete this message. I did everything according to the procedure as explained.

[SkeYT]

Open your DDE program in Tool32 and use function ecu_config_reset and turn off ignition, close car and wait 20 minutes. After that you can clear that error Have fun with RWD

[dankocg]

i will try… Thanks man you are genius

[budddyyy]

@SkeYT is there also a solution for bmw e70 to code out the xdrive system

[SkeYT]

Yes. For E70 need to use Xdrive emulator for E series X cars.