[hollow]

Need help with bsi problem . after reading siemens 95160 to get security code . resoldered eeprom back on but now have immobilser error . , worse is removed it again to check no bad solder and cannot remember which way around chip should be (bad bad memory)
please could some one compare these 2 eeprom dumps.

as new bsi (now with immo error ) has lots more info . compared to old one .

needed security code to add another key and change bsi configuration to add abs module .

pointless defeating immo in ecu as this also comes up with immo fault on dash and engine warning light

2006 siemens bsi with 95160 at an angle on board 2.0 hdi .
would try virginise but keep reading that filling eeprom with just ff ff does not work .

[carman i700]

Picasso new95160=Pin Code - XC0Y
picasso old = Pin Code - HCYT

[hollow]

Hi thanks for that same pin i get for new one ,but old one couldnt calculate pin .

now need a reason why its coming up with immobilser erro,r 20 mins before it worked fine. all tracks to eeprom seem fine tested for continuity

[carman i700]

Hi bsi download and configure and define the switch is OK