[roanoke]

Hi FRIENDS

I have problem with Nissan Terrano II 2002 2.7 TDI.


I have the following errors in ECU:

P1612 "CHAIN OF ECU-IMMU"
P1610 "LOCK MODE"


   

   

The engine does not start. I do not have a Security Card for Nissan Consult. 
I can only read errors from the engine controller. 

I performed the following procedures:

   
   
   

- have been done, the car still won't start.

And now I don't know where to look for a solution to the problem

 - should I do IMMO OFF (if so, how to do it? Read the eeprom?
 - perform some synchronization? But how? What device?
 - replace NATS? 
 - replace ECU (bosch edc)? 
 - BCM? 

I only have one key.

This indicator, when the ignition is on, sometimes comes on and sometimes goes off. With the ignition off and the doors closed, this light behaves normally. 

   


I have devices: 

- nissan consult 2 (software without security card) 
- SVCI2020 
- CK100 Key Programmer tool
- Lonsdor key programmer tool

I don't know the synchronization option anywhere 

Any ideas?