[pyvotel]

Hello,

The car doesnt go more than 3000rpm and there are no dtcs on the diagnosis. Has anybody encountered this problem before?

[gabivw]

Hi
Check dpf
Is full
Or clean dpf
Try activate regeneration 
And see.. Value.. In mg

[pyvotel]

Hello,

The car doesnt go more than 3000rpm and there are no dtcs on the diagnosis. Has anybody encountered this problem before?

Also, does anybody have an original file for this car?
EDC17 P610_CB.VD1A
1037515127:P610D10I

[DavidForgac]

I am dealing with a similar problem, but Kia sportage 2008 2.0 crdi 103kW EDC16C39
The car had a bad egr and a problem with passing through the DPF.
Car already has EGR removed (blinded) DPF (removed from car).
-all software removed
-Cleaned throttle valve
-cleaned MAF

after cleaning the MAF Yesterday and this morning the car ran normally at full power and revs above 3000 rpm. I suspect a camshaft or cranksahft sensor because after warming up the car already goes to 3000 rpm.
And I don't like the throttle either. I captured LIVE data only with LIMP mode, I need to track the values tomorrow when the car is not in LIMP mode.

Also no dtc.

[DavidForgac]

Try to give your car full throttle after starting. The car exceeds 3000rpm and falls asleep at 3000rpm. Live data throttle 4.7° this value does not change. With the throttle off, the car also starts and behaves the same. For her to be the cause? I will try to take it out and disassemble it to see if there is any oil in it.

[DavidForgac]

The cause was the throttle valve, the teeth on the gear inside the valve were broken.