[FinnY]

Hi i try to make 1st tuning edc17c64, i have experience with other ecu like edc15,edc16, sid 206 but now i want to learn someting in edc17.
Car audi a4 b8 2015 2.0 tdi 150hp > stage 1 180hp
I changed some limiters, driver wish, turbo limiter, desired airlowboost, torque limiters, Nm to IQ, smoke map and now i want to change lambda maps but max value for lambda for 1250 mg/hub is only 16.17 afr. Maybe I calculated the maps incorrectly, but looking at these values, it is not worth changing these values in lambda
Can someone check this mod and will advise you on how to do stage 1 better.
Thanks for help in advance

[loki954]

16.17 is "lean", you need "rich". For base tuning you could leave the lambda maps.
"Timing " is not touched, two injection maps are wrong "361ff2/3622da" DW maps are not touched only for revers gear is change. several torque limiter as well. have two more maps for inj/time

[FinnY]

Thank you for your answer.
AFR in lambda map for diesel shouldn't it be 17/18 after tuning? At 16.17 the mixture will not be too rich?
The SOI map i didn't change, only i have changed one duration map
In my stage 1 my max request Nm is 433
On driver wish i have in 100% request 496 - 588 Nm
in 85% 429-517 Nm
in 65% 249 - 395 Nm
Then i think only could be change driver wish for 65%
What wrong with 361ff2/3622da ?
what do you mean "have two more maps for inj/time"??

[loki954]

Thank you for your answer.
AFR in lambda map for diesel shouldn't it be 17/18 after tuning? At 16.17 the mixture will not be too rich?
The SOI map i didn't change, only i have changed one duration map
In my stage 1 my max request Nm is 433
On driver wish i have in 100% request 496 - 588 Nm
in 85% 429-517 Nm
in 65% 249 - 395 Nm
Then i think only could be change driver wish for 65%
What wrong with 361ff2/3622da ?
what do you mean "have two more maps for inj/time"??

my guess is that you don't read what i wrote ......
let me write that one more time for you and hope this time you will read it !!!!

now you need to learn what is rich and lean .......rich is below 1 lean is above 1
have two more duration maps
i wrote that you change DW only for reverse gear .
with 361ff2/3622da ...all is wrong for start your x an y axes that you used the changes you made is from upper right corner to bottom left corner skipping lines

[FinnY]

ohh now i understand afr thanks for table.
I only find one more duration map 15x10 
on which map the axes are incorrectly marked?

[loki954]

i am done.........you just want to give it to you with a spoon ......all is written twice .....