[germancarfan]

Node

This was the PT-CAN

Let me scope the PT-CAN2 as well with other scope and report back.

Let me scope the 15 WUP I only did a voltage measurement on that previously and found battery voltage.

I did see the crash signal wiring from the ACSM so I disconnected it and still EME was still offline. Let me take another look at that as well though to be sure the can network was fully asleep post ACSM disconnect. Also I can disconnect the service connect and connect back post ACSM disconnect.

Here is a screen shot of my original measurements which includes the crash signal wires

https://prnt.sc/i1lnMBtglnVK

Yes the lights and fan are disconnected to reduce consumers.

Very good information here. Thank you.