[pepi]

I need to swap ECU for VW Caddy . Problem is that I dont have car near me and I 
have ONLY one try chance because car is thousands km from me.
The label is the same 
03L 907 425 C

sw is different but I can reflash it with the same sw later 
In attachmet there is ori and spare eep and flash data 
with inf detailed data from two ECU-s.

[raffy haddad]

I need to swap ECU for VW Caddy . Problem is that I dont have car near me and I 
have ONLY one try chance because car is thousands km from me.
The label is the same 
03L 907 425 C

sw is different but I can reflash it with the same sw later 
In attachmet there is ori and spare eep and flash data 
with inf detailed data from two ECU-s.

I couldn't decode from flash and eep 
What tool you read with ? 
Any way this new eep should be good 
Report back
P.s ,your spare ecu have dought about data

[pepi]

I have used SMOK UHDS for reading thru boot mode.

[raffy haddad]

I dont have smok to know if do good reading or not but tool say flash not known and manually check its too different from others flash
Any the decode was made from id and eep
Good luck

[ROD-BENDERS]

And... what is powerclass of car ??

[repair]

There is an option to make a clone of the original block - using the processor IDs from both blocks and eeprom dumps from them.
But keep in mind that the HW blocks must be identical.
If you want, write in private messages.

---

I couldn't decode from flash and eep 
What tool you read with ? 

You couldn't do this because the theme author doesn't have full flash dumps...

[pepi]

Power class is the same on booth ECUs 55
I have wrote the eep , after that I have read ECU ... CS , PIN and mac now is the same as original.
I hope it is going to work.