[KaiO]

Yeah, I understand your aim, but I don't see how a written problem is different to a problem that's obvious. You wrote you have the reason found, but there's no reason given, just a description of the problem, MICHA

By the way: there IS a solution.
Use a DHCP server for programming these series in order to avoid this problem.

[ap90500]

This problem with ICOM has existed for a very long time, probably since the NBT was introduced. If there is a NBT in car, all control units in MOST bus must be flashed by one of these two methods:

1. Use DHCP server to assign ip to car
2. Use ENET cable for flashing

This is in effect also when using E-sys for flashing.

Some MOST bus control units: NBT, kombi, top hifi amplifier, dvd-changer.

[ruben_17non]

This problem has existed for a very long time, probably since the NBT was introduced. If there is a NBT in car, all control unitd in MOST bus must be flashed by one of these two methods:

1. Use DHCP server to assign ip to car
2. Use ENET cable for flashing

This is in effect also when using E-sys for flashing.

Some MOST bus control units: NBT, TCB, kombi, top hifi amplifier, dvd-changer.

TCB is possible flash. not have MOST.
The rest is correct

[ap90500]

Thanks for correction. No BMW Assist in Finland so no TCB ecus.

[abuqutaita]

This problem has existed for a very long time, probably since the NBT was introduced. If there is a NBT in car, all control unitd in MOST bus must be flashed by one of these two methods:

1. Use DHCP server to assign ip to car
2. Use ENET cable for flashing

This is in effect also when using E-sys for flashing.

Some MOST bus control units: NBT, kombi, top hifi amplifier, dvd-changer.

Could you elaborate on #1? I've not done anything special to connect using E-sys and successfully flashed NBT and KOMBI. The only special connection option is to connect directly to the IP when flashing ZGW; else, I just connect using VIN.

[ap90500]

So you have used option #2, "use ENET cable for flashing".

[abuqutaita]

I just reread your post and realized you weren't specifically referring to flashing these ECUs using ISTA/P, but just generally speaking about using an ENET cable (if instead by using E-Sys).

[Sabreace]

Anyone can Post the exactly adjustment for Router; Icom and Networkcard
to flash NBT with actual native Ista_P? or complete Sceernshot

I'm in a worst case and Esys is not yet my friend

THX and Regards
Sabre

[Fx82]

Just add a router and connect the icom to it and offcourse your laptop to the router.
Open a browser and type: ip address of your icom:60080 (User name: root Password: NZY11502) and change lan setting to dhcp. Reboot icom and check with iToolRader the new ip address of your icom. It should be 192.168.x.x
Fire up ista-p and do your coding.

[mipe]

What router with DHCP would you recommend?

Thanks