Unfortunately we do not accept new members for free, Now Registration cost 30€, if you are interesting Send Email to [email protected]
Programming KOMBI and NBT fails on F series
03-04-2016, 12:19 PM,
Post: #74
|
|||
|
|||
RE: Programming KOMBI and NBT fails on F series
(03-04-2016, 05:59 AM)Terabyte Wrote: I know that flashing NBT with ENET and Esys works. http://cartechnology.co.uk/showthread.ph...#pid147928 I posted the solution literally two posts above your original post. You don't need a router, but you do need a DHCP server on the ethernet interface on your laptop. The problem is that either the ENET or ICOM interface doesn't get an IP to start programming when those modules are flipped into boot loader mode. So they basically time out and abort programming. DHCP Server works the same with ENET or ICOM, it'll hand out IP addresses to all the devices connected to the Ethernet port and inside the vehicle. |
|||
Reputation: +1 - bawareca [+1] | |||
« Next Oldest | Next Newest »
|
Users browsing this thread:
5 Guest(s)
5 Guest(s)
Return to TopReturn to Content