[dadal]

Hi to All,
I want to read this ecu by galetto v54 ( bootmode )but i have dont yet ecu , I want to be sure that I everything correct do.
galletto manual say :
boot pin20 (gray cable of galletto ? )
+12 V : pin 51,49,33,17,18
GND to chassis of ecu

should I select which choice in the menu of galetto ?

Tool Boot --> STF10xxx---> ?
or
Tool boot --> Siemens -Infenion C167-----> Bosh ME7 1 micro flash 400 ?

have this ecu which microcontroller inside ?

[lukasx2]

Once upon at time I, ve read and write this ecu using old galletto 1260 in boot mode without problem. Pinout is good, remember to feed ecu with good power ( I'm using a car battery)

[dadal]

Once upon at time I, ve read and write this ecu using old galletto 1260 in boot mode without problem. Pinout is good, remember to feed ecu with good power ( I'm using a car battery)

thanks mate, I have never seen this ecu, I collect information before I go to work with this ecu, I have galatto v54 and want to make right choice in the menu