CarTechnoloGY

(19-09-2017, 20:21 PM)Zocker010 Wrote: [ -> ]Yes i have a VAS 6430 table. But i retrofit a A5 Front Camera into Mk5 but first problem is that my Motor ECU does make trouble shooting when I want to put the ZDC file into control module and after solved this problem i get an upload error.

Which files does I need when i would upload data sets with ODIS-E?

Here is a picture of my VAS Table. If someone need the messurements or Adobe Illustrator File you can write me.

I know odis can handle .xml files or odx but that requires of course you have access to the raw data from zdc file or else you can try online access for parameter files.

Ok thanks a lot. I hope a friend of mine which work by volkswagen can send me the files to calibrate my camera

I have only seen VCP allow for calibration data to be written to A5 to make it think it has been calibrated. Everytime you flash with ODIS-E the A5 camera it will want to be calibrated. This is done obviously with "basic" settings in ODIS-S and the necessary equipment. If calibration just requires the board then run "basic settings". It should calibrate correctly.

Camera calibration is done through managed functions via ODIS Service
Parametrization via ODIS E or VCP
What camera do you have,3AA or 3Q0 ?

(20-09-2017, 05:18 AM)jokir Wrote: [ -> ]Camera calibration is done through managed functions via ODIS Service
Parametrization via ODIS E or VCP
What camera do you have,3AA or 3Q0 ?

I have a Camera 3Q0980654G retrofit into MK5.
my friend told me that he calibrate it via Odis-E. I think the most problem I have that the devices ask FIN from Car and the Camera doesn't have any FIN yet and I can calibrate with ODIS-E to told the device my actually FIN.

If you have any tutorials you can send me a PM

ZDC only work with original i think.

Not sure about that. If they did not work they would not have been included.

Back to the question.

I would calibrate cam with VCDs.

Is the camera already parameterized?
Calibration must be done through ODIS S (2.2.6/7)
Autoscan A5 ?

You need a suitable dashboard on PLA3 (SW 1008 )

(20-09-2017, 19:07 PM)jokir Wrote: [ -> ]Is the camera already parameterized?
Calibration must be done through ODIS S (2.2.6/7)
Autoscan A5 ?

You need a suitable dashboard on PLA3 (SW 1008 )

No the camera is not parameterized because VCP show me an error when i upload ZDC Container.

I will post a scan of A5 Cam tomorrow.

You need to code your camera control module before any calibrations. VCDs website guides how you will compute this code.