How to Read FIS Module - Printable Version +- CarTechnoloGY (https://cartechnology.co.uk) +-- Forum: All About IMMO/ECU , ChiPTuninG , Dashboard , Locksmith , AirbaG , Carradio (https://cartechnology.co.uk/forumdisplay.php?fid=3) +--- Forum: CARRADIO / NAVIGATION (https://cartechnology.co.uk/forumdisplay.php?fid=14) +--- Thread: How to Read FIS Module (/showthread.php?tid=104) Pages:
1
2
|
How to Read FIS Module - Bonus - 25-09-2013 How to Read FIS Module Read internal i2c memory to get original code Clip Pinout: Port2.1 - VCC ( +5V ) Port2.2 - SCL ( clock ) Port2.3 - SDA ( data input/outout ) Port2.7 - GND ( ground ) P.S Read FIS as 24C16,24C32,24C64 RE: How to Read FIS Module - nigrou - 26-11-2013 I did read with PonyProg2000 look here be easy RE: How to Read FIS Module - alexandr1966 - 23-09-2014 Hi! I have VW radio navigation Blaupunkt 7 612 002 622 7L6035 191 NX. I have connected the device to PonyProg with SCL, SDA and groung. Please tell me: the power 5V to 24c32 must be served from outside with turned off device? Or from internal power supply? Thank You! RE: How to Read FIS Module - audiopoint - 23-09-2014 Connect GND SCL SDA from programer connect NAVI 3x+ and gnd turn navi on wait 10 sec until on display CODE or SAFE read FIS good luck RE: How to Read FIS Module - alexandr1966 - 24-09-2014 (23-09-2014, 20:50 PM)audiopoint Wrote: Connect GND SCL SDA from programerThanks for your answer. I read FIS module as 24c32 - right? Or should read as 24c64? RE: How to Read FIS Module - audiopoint - 24-09-2014 (24-09-2014, 07:51 AM)alexandr1966 Wrote:(23-09-2014, 20:50 PM)audiopoint Wrote: Connect GND SCL SDA from programerThanks for your answer. I read FIS module as 24c32 - right? Or should read as 24c64? depence of model of navi usually 24c32 anyway send dump that you read some of "GA experts" will look RE: How to Read FIS Module - otojm - 08-12-2015 (24-09-2014, 11:52 AM)audiopoint Wrote:hi ihave UPA USB is it the same connection like PONYProgrammer in the pic above,thank you.(24-09-2014, 07:51 AM)alexandr1966 Wrote:(23-09-2014, 20:50 PM)audiopoint Wrote: Connect GND SCL SDA from programerThanks for your answer. I read FIS module as 24c32 - right? Or should read as 24c64? RE: How to Read FIS Module - Tecdiag - 21-02-2016 U can use any programmer, u just need to know ur pinout in ur programmer . RE: How to Read FIS Module - volavka - 21-02-2016 (21-02-2016, 12:04 PM)Tecdiag Wrote: U can use any programmer, u just need to know ur pinout in ur programmer . yes any i2c Programmer RE: How to Read FIS Module - ELECTRONICO - 03-04-2016 Thank you friends for help |