(15-10-2016, 17:15 PM)volavka Wrote:  For me not worth , since they sell each script by 50 - 100 euro
if you can create scpripts by yourself then would be good for you ,, if not u must think before buy
good luck

(15-10-2016, 17:33 PM)thusithasam Wrote:  What tool you are recommend?

(15-10-2016, 17:38 PM)volavka Wrote:  

(15-10-2016, 17:33 PM)thusithasam Wrote:  What tool you are recommend?

Good programmer for read memory is UUSP-S (UPA-USB Serial Programmer-S)
you can find scripts for free Here in CT , else you make own scripts if u undestand pascal

(15-10-2016, 17:57 PM)thusithasam Wrote:  I need to do below tasks
1.Air bag crash clear
2.Toyota Steering angle sensor calibration,
3.Toyota Honda Millage correction,
4.Toyota DPF remove

So that above tool UUSP-S (UPA-USB Serial Programmer-S) can do them.

(15-10-2016, 19:59 PM)volavka Wrote:  

(15-10-2016, 17:57 PM)thusithasam Wrote:  I need to do below tasks
1.Air bag crash clear
2.Toyota Steering angle sensor calibration,
3.Toyota Honda Millage correction,
4.Toyota DPF remove

So that above tool UUSP-S (UPA-USB Serial Programmer-S) can do them.

1. For airbag yes UUSP-S supported many eeprom's /mcu's but RMEMBER you must have good softwares to clear Crash (some sw can find at CT)
2. i have no idea about
3. i have no idea too
4. Hmmm this 1st time i hear iprog can do DPF remove , as far i know iprog can't read or identifying maps

may members with experience can post feedback about this tool

Good luck