Solved ✔ Immo off jaguar xk8 1997 - Printable Version +- CarTechnoloGY (https://cartechnology.co.uk) +-- Forum: All About IMMO/ECU , ChiPTuninG , Dashboard , Locksmith , AirbaG , Carradio (https://cartechnology.co.uk/forumdisplay.php?fid=3) +--- Forum: IMMO & LOCKSMITH (https://cartechnology.co.uk/forumdisplay.php?fid=9) +--- Thread: Solved ✔ Immo off jaguar xk8 1997 (/showthread.php?tid=32531) |
Immo off jaguar xk8 1997 - MagnaSound - 08-02-2018 Hello to all I have in the workshop a jaguar xk8 1997 4.0 v8, I need to turn off the immobilizer. I am attaching the photos of the control units (thick ecu) 079700-8250 thanks for the help RE: Immo off jaguar xk8 1997 - volavka - 08-02-2018 Just unsolder the memory TC97101P or fill all lines with FF FF...... well ecu become immo off Good luck Immo off jaguar xk8 1997 - MagnaSound - 10-02-2018 I tried to remove it, but nothing, it gives me error. How can I read or write this eprom? Inviato dal mio ASUS_Z00AD utilizzando Tapatalk Immo off jaguar xk8 1997 - MagnaSound - 16-02-2018 Today I tried again, the engine started! thank you ! Inviato dal mio ASUS_Z00AD utilizzando Tapatalk RE: Immo off jaguar xk8 1997 - snyper - 12-07-2019 (08-02-2018, 23:40 PM)volavka Wrote: Just unsolder the memory TC97101P or fill all lines with FF FF...... Dear Owner, I landed on this thread and it was helpful to the threat starter. I have a 2003 Jaguar X type 2.0L 2X43- ECU. I need to make the ECU virgin by wiping the memory with VID blocks so I can reprogram it. Could you advice which memory to read? Thank you. RE: Immo off jaguar xk8 1997 - volavka - 12-07-2019 (12-07-2019, 16:22 PM)snyper Wrote: Dear Owner, TC97101P is supported by UPA USB-S programmer , read/write ok RE: Immo off jaguar xk8 1997 - snyper - 12-07-2019 Much thanks. Should I wipe it clean?. I read on some forum that to make it new so that you can program the module as new, you need to wipe it clean and solder back. Once again, thank you for taking you time to assist. Regards |