NEED HELP CODING DSC AND ABG - Printable Version +- CarTechnoloGY (https://cartechnology.co.uk) +-- Forum: Discussions All about Software and Hardware (https://cartechnology.co.uk/forumdisplay.php?fid=310) +--- Forum: Automotive Help & Discussions / Software and Hardware (https://cartechnology.co.uk/forumdisplay.php?fid=40) +---- Forum: BMW - Mini - Rolls Royce (https://cartechnology.co.uk/forumdisplay.php?fid=61) +---- Thread: NEED HELP CODING DSC AND ABG (/showthread.php?tid=3691) |
NEED HELP CODING DSC AND ABG - corpus - 14-04-2014 I need help with a few of these error codes im unable to start my car because of the abg and dsc modules http://s326.photobucket.com/user/damian_thomas1/slideshow/ RE: NEED HELP CODING DSC AND ABG - bawareca - 14-04-2014 Wow,this car needs serious work.However i dont see any code that will cause no start,except the CAS codes,perhaps. RE: NEED HELP CODING DSC AND ABG - corpus - 14-04-2014 (14-04-2014, 04:23 AM)bawareca Wrote: Wow,this car needs serious work.However i dont see any code that will cause no start,except the CAS codes,perhaps. Not really that much work. I did a m3 swap most of the hard work is done. The cas codes are related to the mrs/abg module It's a safety features RE: NEED HELP CODING DSC AND ABG - KevinX - 17-04-2014 Does it crank over? RE: NEED HELP CODING DSC AND ABG - corpus - 17-04-2014 (17-04-2014, 02:26 AM)KevinX Wrote: Does it crank over? yes it turns over but the ekp is current not showing up in the list of modules its currently deactivated by the dme RE: NEED HELP CODING DSC AND ABG - gfriedrichi - 04-05-2014 Hi friend, Have you already tried to code using NCSEXPERT ? I used it when i replaced my E39 ABS module and it worked fine RE: NEED HELP CODING DSC AND ABG - abac354 - 06-05-2014 Check the power supply at the EKP and the pt-can. EKP does not show in the list because does not have power or because there is a problem with the pt-can, most likely. RE: NEED HELP CODING DSC AND ABG - corpus - 06-05-2014 (06-05-2014, 22:17 PM)abac354 Wrote: Check the power supply at the EKP and the pt-can. thank you for your input you are correct the dme isnt receiving a hand sake from the mrs module so for safety reason the dme shuts off the EKP thats the reason for terminal 15 at cas module. that is one of the issues i need to resolve. the other issue is dcs/szl steering angle calibration RE: NEED HELP CODING DSC AND ABG - fireblade9 - 21-05-2014 Do you find solution?? RE: NEED HELP CODING DSC AND ABG - corpus - 27-05-2014 (21-05-2014, 16:56 PM)fireblade9 Wrote: Do you find solution?? i resolved most of the codes but im unable to see fuel pump module in inpa or istad im stuck got any advise ? |