+- CarTechnoloGY (https://cartechnology.co.uk)
+-- Forum: Discussions All about Software and Hardware (https://cartechnology.co.uk/forumdisplay.php?fid=310)
+--- Forum: Automotive Help & Discussions / Software and Hardware (https://cartechnology.co.uk/forumdisplay.php?fid=40)
+---- Forum: BMW - Mini - Rolls Royce (https://cartechnology.co.uk/forumdisplay.php?fid=61)
+---- Thread: E63 M6 coding over diagbus error coapi 1000 (/showthread.php?tid=39208)
E63 M6 coding over diagbus error coapi 1000 - weby - 06-09-2018
Hello,
today I update the CCC of an E63 M6 to the lastest I-Stufe with ISTPA-P v65
I have a original ICOM with MOST and the programming works fine after few trys on Port 6802. On Port 6801 they abort at the BO and CCC-A ECU. OK this step are solved.
But if the coding job starts or I try a full car coding, I get COAPI 1000 error.
The same problem in NCSExpert.
ISTA+ works finde and the programming with ISTA-P works too...but what is the problem with ecu coding over the Diagbus?
RE: E63 M6 coding over diagbus error coapi 1000 - inotherwords - 06-09-2018
Are you trying to code it using MOST adapter or not? If so, you need to configure EDIABAS to use MOST adapter first. You can do this using EasyConnect utility.
RE: E63 M6 coding over diagbus error coapi 1000 - weby - 07-09-2018
Ahhh ok...MOST for EDIBAS and then try it again?
But for Ista P normally I dont need this Setup, because they Switch automaticlly.
They programming via MOST, but coding are for all ECUs via Diagbus. But all other ecus outside the MOST-Bus arent coded too.
RE: E63 M6 coding over diagbus error coapi 1000 - inotherwords - 07-09-2018
Actually you can set ICOM to DiagBus or Base, you don't need to use MOST
RE: E63 M6 coding over diagbus error coapi 1000 - weby - 07-09-2018
And Base instead DiagBus is the right configuration to code?
Then I try it and configure the REMOTE.INI.
I use in EDIBAS REMOTE Interface and fix now in my REMOTE.INI the Hosts.
At BASE they is "opps_name". I fix it with my static (dhcp assign) IP of my ICOM.
Thanks for this info!