+- CarTechnoloGY (https://cartechnology.co.uk)
+-- Forum: All About IMMO/ECU , ChiPTuninG , Dashboard , Locksmith , AirbaG , Carradio (https://cartechnology.co.uk/forumdisplay.php?fid=3)
+--- Forum: IMMO & LOCKSMITH (https://cartechnology.co.uk/forumdisplay.php?fid=9)
+--- Thread: A Class dont start from key after emulator installation (/showthread.php?tid=42883)
A Class dont start from key after emulator installation - spanaz1 - 27-11-2018
Hello Falks,
I installed an emulator to A170 cdi Mercedes and car started and drove good but after I switched it off car doesn't fire when starter is spinning but when I push Start the car runs without problem. what can be the problem.
RE: A Class dont start from key after emulator installation - rs@chip - 27-11-2018
(27-11-2018, 17:29 PM)spanaz1 Wrote: Hello Falks,
I installed an emulator to A170 cdi Mercedes and car started and drove good but after I switched it off car doesn't fire when starter is spinning but when I push Start the car runs without problem. what can be the problem.
I do same car with julie and everithing fine so far..did you disconect 2 green wires(can-bus)from immobox?
RE: A Class dont start from key after emulator installation - spanaz1 - 27-11-2018
yes I disconnect, but I used CR1 emulator